VZWJLJ

DrJarmin

Standards Affiliate

• Nov 12, 2009

Sorry, i know this ought to be noticeable, but I am unable to shape it – with studying the manual!

Just how do I link my Yamaha RX3900 receiver to a Velodyne CHT-Q series subwoofer.

The sub enjoys stereo (l+r) inputs (all You will find had in earlier times have had mono inputs) while the yamaha amp hasn’t got a subwoofer productivity where all of those other speaker outputs are observed.

Excellent, and satisfy dismiss your absurdity – i know the answer are clear once I’m sure.

IronGiant

Moderator

• Nov 12, 2009

You must hook up the Pre-OUT Subwoofer regarding Yamaha to either the put or best network from the Velodyne

It is just above the center associated with the three orange digital coaxial stimulant the Yamaha

Edit: apologies that you’s an insight, usually the one you wish is actually a couple further to the right whenever precisely recognized they.

DrJarmin

Standards User

• Nov 12, 2009

All right, many thanks. It actually was the right and left which was puzzling me personally.

How does the subwoofer have gone and best passage?

IronGiant

Moderator

• Nov 12, 2009

In the event your amplifier does not have a devoted sub woofer channel ie try HiFi maybe not an AV receiver, but offers stereo pre-outs, you’ll be able to send out the complete range right and left channel towards sub towards sub to draw out the LFE frequencies from.

Since you have the LFE as a mono indicator you don’t have to hook up to both, however some people do so using a phono splitter. Numerous subs have one or additional of right and left also designated awake as mono, or perhaps you might find the submarine handbook suggests one during the some other.

DrJarmin

Traditional User

• Nov 12, 2009

Ah, ok, In my opinion I have they.

There is certainly a whole lot to learn for this concept.

Many thanks for the allow.

DrJarmin

Requirement Representative

• Nov 13, 2009

One previous thing, is Now I need a cable with a male connector at one end (to connect the Yamaha) and a simple line on the other half (to connect to either the put or right insight regarding the spine belonging to the subwoofer).

We have a handful of AV brings with fittings on, does one just reduce one conclusion away and use that? They’re not particularly hefty evaluate line, only type of line you can get in a Maplins or Dixons. Will that feel sufficient?

DrJarmin

Typical Member

• Nov 26, 2009

You will find attempted to connect the sub – it isn’t operating. What have always been I carrying out wrong?

I bought an RCA line and take off one close. Not sure basically should use middle line, or perhaps the outside cable for put or correct, but attempted both.

The subwoofer just possesses a constant hum.

The other conclusion is actually connected to the back of the RX3900 when you look at the submarine woofer connector, definitely not the right one higher than the 3 lime fittings, but more along right in identical line (witness affixed).

Parts

paulst10

Recognized Affiliate

• Nov 26, 2009

I purchased an RCA wire and take off one close. Unsure basically should make use of center wire, or the outside cable for remaining or correct, but tried out both.

The subwoofer simply possesses a continual hum.

One other end was connected to the back of our own RX3900 into the sub woofer connector, not the main one above the 3 orange connectors, but further along off to the right in the same row (see attached).

There is the line attached to the proper terminal of the Yamaha however, you cannot hook a poor level RCA line to higher level presenter stimulant, should their Velodyne bring RCA stimulant (low/line level) ?

Using just one RCA – RCA wire you only need to hook through the Yamahas sub pre out (usually the one you may be utilizing at this point) to at least one for the the Velodynes low/line degree RCA inputs

How can you publish a picture with the back from the Velodyne or a number of circumstances exact unit number ?